i searched and could not find is there a link
thanks

Vault-Tec (Fallout mod)
Darkstorm

This sniper sprite whenever used shows the outside wight and the rest is not there is it out of palette or what?

Yes, it was out of palette.

Here it is in palette.

In this ini the smoking shells only come out if you are looking to the right what is wrong?

This is a completely separate question: Here I have illustrated the emission dial for AEmitters measured in radians. Based off of observations about emissions I have a series of questions.
Correct me if any of my deductions are false.

I think the angle is to both sides, so inputting a value of pi/4 would get you about pi/2 spread, centered on the 0 line. I could be wrong though.
To make it go in both directions, you'd have to have two emitters, one emitted by the other and with emission angle 180.
Emission angle of 0 should be to the right...

I have never made a very extensive research of AEmitters though, so all of the above is the extent of my knowledge. You could be right in all cases.

Dernit! Further experimentation will have to be conducted!

Alright so I figured out the sprite animation modes, but does anyone know how it would go faster or slower at a single speed? For example, the Coalition Mini-gun has a charge-up, I want my sprite to have a charge up but never change speed. So basically it plays all the frames in order at the same speed.

Right now, at the basic speed, it is way too slow. Any idea on a line that will boost the speed? Example: AnimSpeed = 1.0

Try SpriteAnimDuration = 1000

The 1000 is a time in MS, replace as needed.

I'm not 100% sure it will work on spinup for guns, though. But it's worth a shot.

If you mess with that, the maximum frame rate will be changed, but the spin-up will still gradually go from still to fully spinning when charging up, and vise versa when charging down.

Not sure if that's what you're going for, stranger, but that's how it is, as far as I know.

Can you have animated actors? Like, a torso that changes frames at a preset speed? Even a sprite superimposed on top that rotates correctly would be good too.

Yes, you can.

Uhh, look in the base.rte brains.ini file, it has an animation, looping I do believe. The two lines, SpriteAnimMode and SpriteAnimDuration, or something like that, are what you're looking for. SpriteAnimMode should be left as is for looping, and the duration one is the time, in milliseconds, it take to cycle through the frames once.

Okay, this is off topic, but I searched for so long to find this. Where is the so called "infectious cyborg zombies"? I looked for so long, but I couldn't find this. I decided not to create a whole new topic for this idea.

You could have made a new topic if you like, it's not too big of a deal. This is the better place though. -Duh